[afterburn25]

well the major problem we have is that they dont care give them a program and they hit the cycle start running at 100% rapid and they walk away they do this on an un proven program. not a whole lot i can do about it but i would like to know where i can go to get some macros.

[gar]

070407-2122 EST USA

afterburn25:

In your program make the first moves towards the part with G01 and whatever slow feed rate you want instead of using G00 to approach the part.

In post #11 at http://www.cnczone.com/forums/showthread.php?t=24028 there are some links to some macros.

You really need to study the HAAS manual in the MACROS section. Then create some of you own simple code to play with the capability.

.

[Shotout]

070407-2122 EST USA

afterburn25:

In your program make the first moves towards the part with G01 and whatever slow feed rate you want instead of using G00 to approach the part.

In post #11 at http://www.cnczone.com/forums/showthread.php?t=24028 there are some links to some macros.

You really need to study the HAAS manual in the MACROS section. Then create some of you own simple code to play with the capability.

.

Peter Smid has a pretty good book on Macros too. I've scanned it and am about to sit down and study it in the next couple of weeks. Sub programs and macros weren't taught to me in school so I ordered a couple of his books from Amazon. His presentation of the subject he is writting about is clear and logical, really easy to follow. Hope that helps
Scott