587,753 active members*
2,977 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Milltronics > Aaaargh! Using work coordinate systems with Centurion 6

Thread: Aaaargh! Using work coordinate systems with Centurion 6

Results 1 to 20 of 21

Hybrid View

  1. 04-27-2007, 11:51 PM #1
    2alpha
    2alpha is offline Registered
    Join Date
    Nov 2004
    Posts
    11
    Finally the voice of experience gets it right!
    Reply With Quote Reply With Quote
  2. 04-29-2007, 03:43 AM #2
    sco999
    sco999 is offline Registered
    Join Date
    Apr 2007
    Posts
    14
    You must make sure that in the g54 coordinate edit screen Z is zero before you set all your tool offsets. Set all your tool offsets (H's) first then change the G54 Z coordinate. If you run a program then decide to add another tool, change your G54 Z back to zero then the set the new tool offset (H), then change your G54 Z. I always use a 2" tool offset guage so my G54 Z is always zero when setting tools and -2.0 when cutting.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Hass VF-1 work coordinate problems
    By 1strokedrs in forum Haas Mills
    Replies: 58
    Last Post: 05-11-2012, 05:43 AM
  2. Centurion 5 vs. Centurion 6 and validation codes
    By Turbo VW in forum Milltronics
    Replies: 2
    Last Post: 02-11-2007, 09:35 PM
  3. Work Co-ordinate Systems? Keeps spitting out code in g56...
    By peter.blais in forum Mastercam
    Replies: 7
    Last Post: 07-09-2006, 06:51 PM
  4. Macro Work Coordinate
    By firedog in forum G-Code Programing
    Replies: 7
    Last Post: 06-17-2005, 06:03 PM
  5. Work coordinate in canned cycle line
    By acseatsri in forum G-Code Programing
    Replies: 1
    Last Post: 02-15-2005, 04:11 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules