Hi,
I intend rewinding an existing transformer to use as a power supply for some 60VDC brush servos and to my understanding its desirable to have more than the motors rated voltage available to the controler board (Rutex R990H in this case). My question is how much higher than the rated 60VDC should I aim to get from the transformer?
My other question is in regard to limiting amps to each individual board since it looks like I will have access to the transformer and other componants from a mig welder to use, which means lots of amps, so I would like to regulate the current to each board, any ideas?
Thanks
Splint