I’m in the process of setting up a Leadwell MCV-550S VMC with Dynapath Delta 20 control. I’m going at this without manuals, so now that I’ve hit a snag, I was hoping someone here could help.
At this point I have the control powered up, and I’m able to index the tool carousel, start the spindle, and even activate the draw bar and the air blast. The control runs a diagnostic at start up and confirms NO problems, but I can’t seem to get it to home (move). The Fanuc servo drive boards seem to be powered, with LED’s (green) aglow. Is there a start-up procedure to this control to activate the servos? Anyone have a suggestion?
Thanks