Hi,
My customer has FANUC 6M.
RS-232 port of 6M does not support drip feed mode.
Has any one found a solution to run 3-D jobs on 6M using drip feed mode ?
Deepak
Hi,
My customer has FANUC 6M.
RS-232 port of 6M does not support drip feed mode.
Has any one found a solution to run 3-D jobs on 6M using drip feed mode ?
Deepak
If the control is equipped with a tape reader a BTR may provide the solution.
See - http://www.rym.com/manufacturing/Hardware/btr.html
for an example
Paul Sevin - Ovation Engineering, Inc.
http://www.ovationengineering.com
Try www.adrco.com
They can get you a board to drip feed or we can.
Greg Mercurio -Shop Floor Automations
www.shopfloorautomations.com /619-461-4000
Dear gm 3211,
Quote me on [email protected]
Will your BTR act just like drip feed mode on any other CNC ?
According to me, drip feed will be slow (decided by tape reader hardware), even if we install BTR. Clarify.
Deepak