Ok guys this question is a bit odd but I need your input.
My Tormach, 9x49 Enco knee mill and 14x40 lathe is
in a fairly big shop that is not climate controlled so
when the humidity goes up ever thing sweets’ bad.
I’m constaly spraying my machines with WD40 to keep them from rusting.
So I built a 18x20 shop that’s insulated and climate
controlled.
My question is should I put my machines with there backs to the wall and have a bench in the middle of
the shop or should put there backs facing the middle
and a bench on the wall?
Chris