I've started a new machine build using primarily 80/20 3030 and hiwin 15mm linear slides. Some of the pictures below are from about 2 months ago at the start, up until last night I think. Progress has been slow but picked up a little bit lately.
The pictures below are of the gantry, I haven't even started the main table section, however I did just receive those in the mail yesterday. I hope to get working on that, but getting those 2 pieces together is going to be an undertaking as the gantry already weighs about 80 pounds I would guess, although i'm not an accurate scale so that's plus or minus 50% hehe.
I'll post more as the build progresses.
Ross