Ken. The 4th axis is sitting on my garage floor. I have been working so hard at the day job that I got it up on the table, rep came over and tuned the servo, set some other stuff, I ran one test cut on some foam, just some slots, holes. (Had big plans at this point of course) my buddy calls from NM and wants some foot rests made for his ATV, which are .....flat plates of course.

I lug the 4th off the table with the engine hoist, and do the job for my friend, back to work on Mon and there she still sits. Between my VMC and the trash can. Poor 4th axis.

I'll try and give her some attention next week. (Is a 4th axis female?(talk about a wierd question!))