I just started running a supermax with an 0t controller, when I first used it, it did not recoginze any tool offsets, I spoke with fanuc and they told me which parameters to set, now I get my tool offsets, but after any tool change, it seems to take off the wrong direction.
I notice when I am in single block, I can watch the position numbers change, as I am being very sure sending the machine home every tool and reseting zero with g50 to zero, then using a g50 with a "w" to offset for the distance from the face of the chuck (where my tools are set) and zero on my workpiece. After any tool change, I can watch the numbers reset, then when it calls up the tool, the offsets input do not relect anything to do with the tool offset, not even compounding offsets, HOWEVER, if I simply hit reset and run the next tool by an "N" search, it runs perfectly!?!
Has anyone seen this before?