hi how bad is the saddle that you need to replace the whole unit , turcite can be replace
ball screw nut support can be repaired to
nakatome
Results 1 to 2 of 2
Threaded View
-
08-18-2009, 09:53 PM #2
Registered
- Join Date
- Aug 2007
- Posts
- 31
Reply With QuoteSimilar Threads
-
X3 Conversion - saddle pins
By jlerion in forum Benchtop MachinesReplies: 4Last Post: 07-25-2009, 05:44 PM -
X2 table/saddle/gib alignment
By sansbury in forum Benchtop MachinesReplies: 4Last Post: 12-06-2008, 10:27 AM -
How do I cut my mill base/saddle?
By cnczoner in forum Benchtop MachinesReplies: 9Last Post: 10-09-2008, 11:13 AM -
How to stiffen up the saddle on a mini lathe?
By lucmorton in forum Mini LatheReplies: 2Last Post: 05-21-2007, 01:37 PM -
Forklift laying beside truck
By DareBee in forum Safety ZoneReplies: 18Last Post: 02-15-2007, 10:57 PM
Posting Permissions
