[tld70]

Philip,

dont care about the messages in this mode.
first you have to delete and load the ncmd
after this the plc datas
then the nc datas.
there no datas to load from the eproms.
can you give me the machinenumber, may i can provide the
machinedatas.


regards
Thomas

[Rotormac]

Thomas,

It's manufacture date is 1979. I'm at home so I cannot verify the S/N until Monday but I'm fairly sure it's 101-18.

Philip.

[tld70]

OK Philip,

if you are sure about this datas please
reply it on Monday, also I need the Controller Type
810 GA1 or GA2 or GA3
also I need a Email Adress where I can send the Datas

regards
Thomas

[Rotormac]

Thomas,
I'll confirm tomorrow. Where will I find GA* on the controller?

I'm Philip 'at' watermarkeng.ie

Thanks again,

Philip

[Rotormac]

Thomas,

The machine serial is 101-18.

On the Sinumerik Logbuch this is the information:

SINUMERIK 810 M
6FC3471-OAA-Z
F-NR.: A 1477149
24V DC, 120W

I can't find any reference to GA* in the manuals or on the machine???

Regards,

Philip.

[tld70]

Philip
did you receive my email?
no response from you until now
hope it helps you

regards
Thomas

[Rotormac]

Thomas,
Got your email last evening.

I'll be at the machine this morning and I'll post results asap.

Best regards,

Philip.

[andresantosgodinho]

OK Philip,

if you are sure about this datas please
reply it on Monday, also I need the Controller Type
810 GA1 or GA2 or GA3
also I need a Email Adress where I can send the Datas

regards
Thomas

Hi Thomas,

I know this is an old topic but I have recently purchased a used Chiron FZ 12 S High Speed with a Siemens Sinumerik 810M GA3 controller.
Unfortunatly the machine was disconected for a long time and all parameters were lost.
I have all documents with the original parameters signed in april of 1995 by someone who's name is Buschle.
I have followed the instructions to write these parameters into the 810 but i have not been able to get the machine to turn on.
I would like to know if you can provide the original parameters or a backup copy of them of something that will make the machine run. I might be missing something.
Machine type is FZ12-S 20W
Machine Serial Number is 474-13
NC-Optionen Standard:
B70,B75,N02,E31,F72,B61,F05,E42,N31,N32
NC-Optionen kostenpflichtig:
A04

Thank you in advance,
André Godinho

[lorberdejan]

Hello, Mr.Thomas,
i own a chiron fz12w ga2 1991- number 107-45, and the battery was weak and i lost all parameters,
i contacted the chiron and all they had was a files tea1 and tea2,
do you maybe own some files that can put the chiron back to life ?,
Best regards,
Dejan

[tld70]

Hello Dejan,
I have the S5D file if you have Step5 it is no problem to load this.
Give me your Email and I will send the files.
Best regards
Thomas

[lorberdejan]

Hello Mr. Thomas
My email is: [email protected]