I believe after I do my belt set up ill be well over 15,000rpm with X1.
My motors max is 2.5 hp @ 7200 rpm.
then there is the 3 step pulley it has to go through.
I dont think my bearings were intend to go any where near that.
I was going to get full ceramic bearings just cause they look like there the best .
But I really don't know enough bout them to justifie getting a set of hybrid stainless or ceramic bearings.
Can some of you help me . What should I grab and why? Or will I be all rite with the stockers?
Will I really see any type of difference spending 100$ on a set of bearings?
I know I ask allot of ?s here thanks for the help,
Anthony
On a side note do any of you who have a sx1 or x2 use the tilt head function?
Im bout to buy the new base and Im wondering if I should buy it with tilt or without. Ive read some people say they never even use it . It just gets in the way and its a bother having to tram it all the time.