Hi,
It took some time, I was busy on writing a program to connect to the VFD via the rs485.
Eventually I would like to control the VFD via the emc2 program.

Here are some of my parameters (i hope i don't miss some of the important ones)

A003: 400
A004: 400
A041: 0
A042: 8.5 (Manual torque boost value)
A043: 1.5 (Manual torque boost frequency adjustment)
A044: 0
A045: 100
A061: 0
A062: 0
A085: 1 (Operation mode selection), not sure if that's necessary.
A086: 70 not sure if that's necessary.
B082: 5
B083: 3.0
B086: 60.0
B092: 2
C149: 100.0 (relay turn off delay) Used for coolant pump activation.
H003: 7 (2.2KW motor)
H004: 2 (poles)