Hi all ! We just got the plasma and we are trying to work it out is there some one that is working on a MultiCam that could show me the M & G Codes at the begining of a Job ! Please Please !:withstupi
Hi all ! We just got the plasma and we are trying to work it out is there some one that is working on a MultiCam that could show me the M & G Codes at the begining of a Job ! Please Please !:withstupi
I don't have a plasma, I have a three Multicam routers, my programs start like this:
M90
G90
G70
G75
G97 S14000
G00 T1
G00 Z-0.5
The G97 turns on my spindle, S denotes rpm T1= Tool number.
Below is link to list of G and M codes from Multicam. Maybe you can figure it out from there, wish I could be more help, but I didn't see anybody else jump in.
http://www.multicam.com/eng/Support/mandgcodes.html
Good Luck!