I am a machinist running a Mori-Seiki SV-50 vertical machining center. I am engraving signs and plaques for the company and filesize has gotten to be a limitation. There is a parameter which can be changed to enable the machine to run direct from the PC (distributed numerical control) and I am trying to find it. From the cncci website...
"This is pretty much the same protocol used for distributive numerical control (transfering a program in its entirety), but with an emphasis on handshaking - usually with xon/xoff . Usually a setting paramter controls whether the cycle start button will activate a program in the control's memory or a program from the serial communications port (computer). With Fanuc controls, it's usually on the setting page and labled Input Device. For most control models, it must be set to RMT (For remote) when you want to run directly from a computer."
Been on the setting page and looked at the manuals available and can't seem to find it. Can anyone help?