[jschaudt]

Anyone know a US or even Houston based electronics board repair company that works with Canadian Camtech electronics? Cam Tech no longer will repair our boards after a knowledgeable employee left their company. I have old CMC1 controller cards that die all too often.

[CAMTECHZ7]

Hi, we have the same problem
for repair see this site
http://www.erdweb.com/C.html

if you change your drive for new one or update your machine
i want to know if you have your old
cam tech card we are interested by your cards.

thanks
[email protected]

[master_eng]

I recently purchased a used routermaster and have four driver cards available from the CMC 3 that came with it. I have not used them so I can't verify how well they work; however, I was told that the router worked perfectly the last time it was used and I do not see any visible signs of damage. I can send detailed photos of all the cards if anyone is interested. I also have the backplane board out of that same unit that I would be willing to throw in for free if anyone is interested in buying all four cards.

[erdweb]

Thanks to this forum we have just completed at ERD our full range repair strategy and can cover in less than a week ALL old router repairs.

We are offering single axis repair but highly recommend full rebuild to the whole control since the connectors on the backplane are a major problem in the system!

We now stock ALL parts necessary for this process and have enjoyed fully developing the whole Camtech line!

So if you have a problem on this system or ANY machine tool send me an email!

[email protected]


I answer this email so with 20 years as an Engineer involved in electronic service rest assured I can give you some level of guidance.

[cdashok]

hi, i recently bought camtech microstepper from ebay and they havent given any connection manual, so if some one help me how to connect and voltage levels. please reply in the forum r mail me [email protected]