this maybe over before it began. i had not yet saved a drawing that i was working on and the power went out. is there a temp file somewhere that it can be retireved from?
i know i know always save as i go. battery backup. etc. oops my mistake.
thanks
bear
Thread: retrieving files?
Results 1 to 3 of 3
-
09-11-2007, 01:23 AM #1
Registered
- Join Date
- Jul 2006
- Posts
- 70
retrieving files?
-
09-16-2007, 11:36 PM #2
Registered
- Join Date
- Sep 2005
- Posts
- 221
if autosave is turned on, yes.... look in your config options, and it will show
you the directory. the files will be called xxxx.sv$ I believe, all you do is rename it .dwg and your in, at least up to your last save or autosave..
Set autosave to every 5 or 10 minutes if you want a lot of safety....
-
09-17-2007, 04:34 PM #3
Registered
- Join Date
- Jul 2006
- Posts
- 70
thank you so much!
bear
Reply With QuoteSimilar Threads
-
ncp files to dxf or dwg
By greenmanor in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 10-27-2005, 04:33 AM -
Retrieving Stepper Motors
By andy_ck87028 in forum Stepper Motors / DrivesReplies: 16Last Post: 10-25-2005, 10:42 PM -
DXF files???
By f.100 in forum Uncategorised CAM DiscussionReplies: 2Last Post: 02-11-2005, 05:33 AM -
DXF or PLT files
By signIT in forum DIY CNC Router Table MachinesReplies: 1Last Post: 07-01-2004, 10:57 PM
Posting Permissions
