After adjusting x and z value for turret#2, I have EX1992 alarm every time I install tool presetter and also the PST button doesn't work too. When I remove the arm alarm goes off.
Any help? Thnx
Thread: NT4250 Tool Pre-Setter alarm
Results 1 to 3 of 3
-
08-24-2010, 12:36 AM #1
Registered
- Join Date
- Aug 2010
- Posts
- 0
NT4250 Tool Pre-Setter alarm
-
09-07-2010, 06:07 PM #2
Registered
- Join Date
- Apr 2006
- Posts
- 7
Hi
How much did you adjust it by and have you tried putting the old values back in?
Matty
-
09-07-2010, 06:20 PM #3
Gold Member
- Join Date
- Feb 2009
- Posts
- 6028
So I would assume this is a removable presetter. If there is no alarm with the cap on, but it alarms with the arm in, I would assume either the contacts are not mating up with the mount correctly, or the head went bad in the arm. If the machine does not see the correct signal from the arm, it will not go to PSM mode.
PS, I have seen the contact pins on the arm/mount actually broken off, check there first.
Reply With QuoteSimilar Threads
-
Tool Setter Macro for M-V60C and Metrol Setter
By mitshack in forum Mazak, Mitsubishi, MazatrolReplies: 1Last Post: 02-02-2013, 12:08 PM -
Tool Pre Setter
By Allen123 in forum Mach Software (ArtSoft software)Replies: 0Last Post: 03-16-2009, 05:29 AM -
Tool setter macro for M-V60C and Metrol setter
By mitshack in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 10-06-2008, 02:38 PM -
Tool setter alarm
By Nine Blue in forum Mazak, Mitsubishi, MazatrolReplies: 3Last Post: 02-18-2007, 01:00 AM -
tool setter
By ACME in forum MetalWork DiscussionReplies: 8Last Post: 07-30-2005, 05:15 PM
Posting Permissions
