Hi Everyone,
I have had a dyna cnc table with mach3 controller up and running for about 4 months. Hi have a thermal dynamics 101. Recently while cutting the torch will shut off. At first it was once in a while, now it will only cut about 2-3 inches and shut off. it is worse on thinner material. Any thoughts? I am sure it is the plasma cutter. I have changed all consumables, checked for water in lines, checked pressure and adjusted amperage settings like a villian but it still is continuing to do it.
the operation manual and the maintainence manual both point to overheating, but it will do it just 30 seconds into being turned on. The fan is working and the kicker is that I can use the hand torch without a single problem....
Do y'all have any thoughts?