Can some one please explain to me how to adjust the turret. I hate to admit but I had a small crash today. While setting up a new program I reached for my safety glasses which I should have had on and a outside tool holder lightly hit the chuck while it was turning. I got it stop with very little damage except for a broken center drill and a ding on the tool holder from the chuck jaws.

But now I have bumped the turret out of wack so that the tools are not on the centerline. Not sure how best to explain it but if I face off the part the tool is about .025 above the centerline. So the turret needs to rotate down in its normal tool change rotation about that much more.

Any ideas or suggested would be greatly appreciated

Thanks
Jason