Hello everybody,
I would like to retrofit my Maho mh400c with emc2.
This is because the old philips 432 control is broken and it's getting harder and harder to find the right parts for it.
I would like to use the original indramat 3trm2 servo drive and the linear encoders.
I found the following thing: http://www.cnczone.com/forums/showthread.php?t=74532/
It takes the step/dir signal and makes it into an +10v/-10v signal.
Perhaps its usefull?
Any info that can be usefull for my build would be highly appreciated.
![]()