[ger21]

Still evolving. Have to abandon Flash for now due to technical difficulties with my control PC. Can't design a screen that I can't use.

This only looks good at it's native size, because the small icons and text don't scale well. The attachment is the actual size.

[boydage]

Hi. I hope ok to tack onto this thread. I have installed the 2010 screenset and like it very much. I am having a couple of small issues though and wonder if someone can help.

Problem one is some of the buttons are not working. The ref home, tool change and auto zero are the ones for a start. I have transfered the macros over but am at a loss as to what I can do. I tried to set the program limits on the 2010 setup and it will not accept these either, just going back to the default if I enter.

Second - and more electronic issues. I have run the probe wiring and attached the earth to the chassis of my machine. Unfortunately now if I run the spindle the interferrance causes my steppers to rattle and move. How would I isolate the spindle from the breakout board to avoid this? Hmmm.

Regards
Boyd

[ger21]

One question though, is there a way to automatically set my work coordinate Dro's with the values from my machine coordinate Dro's at the end of homing?

What you're asking, is to set the offsets to zero. If you don't have any Homeoffsets set, you can simply set the DRO's to zero, using:

Call SetDRO(800,0)
Call SetDRO(801,0)
Call SetDRO(802,0)

If your using Home Offsets, replace the zeros with the home offsets

[krugshouse]

I get this as well. This also makes my amchine run slow.