When I load program from Partmaker into our Citizen K-16E. I get an error stating illegal data format. I looked a little closer and noticed some of the specs. for toolholders were missing. Anyone else have this? I,m loading this on a flash card.
When I load program from Partmaker into our Citizen K-16E. I get an error stating illegal data format. I looked a little closer and noticed some of the specs. for toolholders were missing. Anyone else have this? I,m loading this on a flash card.
Are you using the correct post processor for the K-16 from Partmaker?
www.atmswiss.com
Post the code or send it to me in txt format and I will load it to see if I get the same errors. Then, correct if so, save, and send it back to you.
[email protected]
or [email protected]
Make sure your cutoff process is the last process on the process table. This needs to be done to have the MCData correct.
There may also be some different options on your machine and we may need to customize the MCData for you. If the above does not work, contact [email protected].
Bill Cain
www.partmaker.com