587,025 active members*
3,917 visitors online*
Register for free
Login

Thread: gcode problem with mach3 (jogging works fine)

Results 1 to 4 of 4
  1. 08-03-2013, 05:41 PM #1
    gurasha
    gurasha is offline Registered
    Join Date
    Oct 2012
    Posts
    13

    gcode problem with mach3 (jogging works fine)

    I have strange problem.
    when I use jogging in mach3 everythings fine (all axis work fine) cnc responds correctly all motors move. when I load gcode (even with ONLY G0 commands) motors movel VERY VERY slowly and incorrectly. in mach3 it shows me axis have moved with 40 in realuty 1. when I turn jogging everythings fine. can anyone help?
    Reply With Quote Reply With Quote
  2. 08-04-2013, 01:59 AM #2
    doorknob
    doorknob is offline Gold Member
    Join Date
    Jan 2010
    Posts
    2141
    Is it possible that your acceleration settings are too aggressive and so the motors are losing steps or stalling?
    Reply With Quote Reply With Quote
  3. 08-04-2013, 04:24 AM #3
    gurasha
    gurasha is offline Registered
    Join Date
    Oct 2012
    Posts
    13
    Thank you for response but if so then my cnc wont work properly on jogging , but it does. everythngs ok when koggin.g problem starts when I run gcode.
    Reply With Quote Reply With Quote
  4. 11-12-2014, 01:05 AM #4
    dougputt
    dougputt is offline Registered
    Join Date
    Aug 2007
    Posts
    298

    Re: gcode problem with mach3 (jogging works fine)

    did you get this working? I'm having same issue
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. fuji fsd80 drive works fine in manual but not in MEM or MDI
    By jolulank in forum Servo Motors / Drives
    Replies: 0
    Last Post: 02-25-2014, 03:48 AM
  2. VF-3 wouldnt change gears now suddenly works fine with an air leak
    By GITRDUN in forum Haas Mills
    Replies: 1
    Last Post: 10-28-2013, 06:51 PM
  3. Need help getting parport to work, works fine under linux.
    By CptanPanic in forum Mach Software (ArtSoft software)
    Replies: 1
    Last Post: 07-29-2012, 02:59 PM
  4. Problems with Mach3 Jogging.
    By Ncrazyballa in forum Mach Software (ArtSoft software)
    Replies: 1
    Last Post: 04-30-2012, 01:27 AM
  5. solid works to gcode
    By bradeyk in forum Solidworks
    Replies: 5
    Last Post: 08-15-2011, 08:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules