Anyone with ideas or know the best chemicals to remove corrosion and rust from an older CNC lathe Turret.
Lots of corrosion and rust where the coolant has been.(heres a photo) Attachment 505326
Any help or suggestions would be great
Thanks
Anyone with ideas or know the best chemicals to remove corrosion and rust from an older CNC lathe Turret.
Lots of corrosion and rust where the coolant has been.(heres a photo) Attachment 505326
Any help or suggestions would be great
Thanks
You can use washing soda and a battery charger to remove rust on anything you can submerge in a tank. https://www.garagejournal.com/forum/...emoval.154196/
Hi,
a moderately strong solution (5%-10%) of phosphoric acid. Paint it on, leave for an hour or so to dissolve the rust, and then thoroughly rinse it off.
This is the basis of quite a few of the 'Etching Primer' solutions. Old school but it works.
Craig