Hello,
Need to change IP address for FTP...can't write change becuase of write protect parameter. For the life of me I can't remember where to turn that off. I have done it before. Should have documented it.
Thanks in Advance
Hello,
Need to change IP address for FTP...can't write change becuase of write protect parameter. For the life of me I can't remember where to turn that off. I have done it before. Should have documented it.
Thanks in Advance
Setting 61 input i believe. Been a while since ive been on a mapps1/2
Offset button, then 1 of the softkeys, set parameter 0 to 1
Hello,
I pressed "Offset" hard key -> "Params" -> 61 -. changed from 0 to 1. Tried changing the IP address. Sill get the write-protect message.
Thanks
Its the first parameter on the top. Called Enable write ore something like that. Be sure you are in mdi mode.
Parameter 61 is for new fanuc i think!!
So,
Offset, settings, parameters write=1
Miller-Mapps control...
Smecher- change Mapps parameter lock. Same screen, make sure your in MDI. Not in offset-setting page like a standard fanuc. 61 is not the parameter, its the mapps screen. Says system parameter lock/unlock and Mapps parameter lock/unlock.
Hello,
After fumbling though the menus I found the setting:
"Settings" hard key -> 50 for "Settings" -> "NC Parameter Write" change from 0 to 1.
Thanks everyone for your input, appreciate it.
Thanks