I recently purchased a PMDX-109 for addtional outputs. Does anyone have any idea how to get this working with Mach3?
In Mach3, I've got port 2 enabled. In ports&pins, I've got output signals #7-14 configured to use port #2, pin 2-9.
I've got the PMDX-109 plugged into Port 2 on the Smoothstepper and on the PMDX-109, I have the jumper configured to 'enable by power on' which should allow me to test the relays on the board by setting the port hi or low.
If I look at the SmoothStepper Device Monitoring window, I can see the ports active when I set the outputs to 'Active Low'.
Any help would be appreciated!!!!