[Roadstercycle]

I need a little insight here. I've built a couple CNC machines but this is the first time using a VFD for the spindle and was wondering if it puts out any bad RF that would mess with my DRO or Mach 3. I supplied a picture of it and it's mount that I would like but it's not set in stone yet. It's going to have Mach 3 control and manual ability and that's why I mounted it where I did. Anyone have any thoughts other than try it and if it works leave it there or if it does not work move it. Just wondering if any one has had any cross talk issues. Thanks for the thoughts in advance.

Jack

[Al_The_Man]

I always put mine a main control enclosure, in one case I had two VFD's in the same cabinet.
Al.

[Roadstercycle]

I always put mine a main control enclosure, in one case I had two VFD's in the same cabinet.
Al.

Thanks AL, still looking for a RF answer. In the main control box would be fine if it was pure CNC and not a combo setup that I build.

[ninefinger]

Check the front panel - it might be removeable so you can mount the main body in the main control box and just mount the panel locally?
Mike

[Roadstercycle]

[QUOTE=ninefinger;1752688]Check the front panel - it might be removeable so you can mount the main body in the main control box and just mount the panel locally?


It is actually removable, I may have to find a long ribbon cable.

thank you,

Jack