[Borisw37]

Recently started using SolidCam for a hobby CNC router.
Cutting a rectangular pocket of course leaves rounded corners.
Is there an option in SolidCam to cut deeper into corners?
This way a 1'x2" rectangular pocket will truly receive a 1'x2" rectangular peg, not counting the tolerances, etc...
Example is the two bottom corners in the attached image. Blue outline is the original rectangle pocket.

[alan_3301]

Just update your geometry to match reality. Any reason not to?

[Borisw37]

That is certainly an option, was hoping there is a SolidCAM option.
The only problem is that it is no longer "parametric". The size of the dog-bone (the notch) should change based on the size of the bit / mill used.

[JFettig]

Draw it how you want it, its quite simple.

[DarkStarMedia]

It would be nice, but I just add it to my geometry when I create a part as others have suggested.

Richard