Attachment 328468

Hi,
I have been helping a friend who bought my previous router off me, a CNC 6040 with the .8kw water cooled spindle.
I've follwed the setting setup as shwn in the image above that i got from this forum discussion 6040 CNC (800 Watt Spindle VFD Settings Problem) [Archive] - Woodwork Forums
But there is one setting that I cannot get to work right and that is the RAMP UP SPEED.
I had the same issue when I owned it. Everything else works as it should including the ramp down speed.
Basically the spindle just kicks into full speed when the start button is pressed and this can't be god for the spindle.
I changed the Pd014 and Pd015 settings to 5 seconds each but no effect on the ramp up speed.

Any one got any ideas off what I've got wrong with the settings?