586,713 active members*
3,016 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Stepper Motors / Drives > DD6600T4V1 is anyone tested this product.

Thread: DD6600T4V1 is anyone tested this product.

Results 1 to 2 of 2
  1. 02-10-2017, 02:02 PM #1
    janis93
    janis93 is offline Registered
    Join Date
    Feb 2017
    Posts
    13

    DD6600T4V1 is anyone tested this product.

    Hello

    I build grbl cnc and I need little more power than drv8825 can offer. So I find TB6600 can offer wath i need ( I know they are not best quality but for my hobby cnc they work). and then i found one where are 4 of them build together. is this more relayable than the paralelport version of 4axis tb6560 boards. I know they are bretty bad I have one layng around.

    CNC TB6600 4 Axis Stepper Motor Driver Controller 2 Phase 4A 150khz DD6600T4V1 | eBay

    Sorry for horrible english
    Attached Thumbnails Attached Thumbnails Screen Shot 2017-02-10 at 15.02.01.jpg  
    Reply With Quote Reply With Quote
  2. 02-14-2017, 05:48 PM #2
    Biggs427
    Biggs427 is offline Registered
    Join Date
    Feb 2016
    Posts
    286

    Re: DD6600T4V1 is anyone tested this product.

    I've been on the same path as you are. I started with a grbl shield, then switched to TB6600.

    IMO it would be better to buy 4 TB6600 driver instead.
    That way, if one goes boom, you only have to replace the defective one.

    I paid 8$ per drive shipped; don't remember if it was Ali or Ebay.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Need I80 card tested
    By ka67_72 in forum Uncategorised MetalWorking Machines
    Replies: 1
    Last Post: 09-06-2016, 09:20 AM
  2. FINISHED MDF CNC MACHINE TESTED WITH PEN
    By ninja0731 in forum DIY CNC Router Table Machines
    Replies: 0
    Last Post: 05-18-2014, 03:45 PM
  3. anyone have tested ROBOTMASTER??
    By patriciooholegu in forum Mastercam
    Replies: 0
    Last Post: 01-20-2009, 11:54 AM
  4. Tormach Accuracy/Roundness tested
    By keen in forum Tormach Personal CNC Mill
    Replies: 14
    Last Post: 07-05-2008, 04:54 PM
  5. How I tested my Y for repeatability
    By IQChallenged in forum CNC Wood Router Project Log
    Replies: 3
    Last Post: 05-12-2008, 01:41 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules