Thanks in advance for taking a look. So my axis selection switch started going out in my pendant, and my machine has the PCB-0200 board which means the switch is soldered on, not a huge deal, i was able to find one and ordered it but its a couple weeks out. Long story short I was going to just take the knob off and use the keyboard to select which axis I wanted to jog but the owner decided to come take a look, and by look i mean grab the switch with two pairs of channel locks and twist back and forth :stickpoke. This made the machine not let me even be able to get into jog mode. With fingers crossed and high hopes I de-soldered the now mangled switch from the board hoping to be able to go to my original plan of using the keyboard, but to no avail. I really can't wait to get the machine back up as the parts are already piling up, is there any way to put a temporary jumper between any of the 13 solder points on the board to get my up and running till the new switch comes in? Or am I screwed and just going to have to wait. I tried to find a breakdown of the board but all I can seem to find is listings for the board itself. Thanks again for reading.