[Gautier]

Hello guys,

I thank you for your help. Especially "Automationtechnic". Now I am able to run the spindle using the VFD's panel control. Now I need to run it using the USB CNC controller card (see picture). As Automationtechnic told me that they are not familiar to USB CNC controller board, I still need help in order to control the VFD through USB CNC controller:

1. How to connect the VFD and USB CNC? and the position of jumpers on USB CNC board; or if the attached picture is correct?
2. Which VFD parameters to change?
3. Do I need to change the VFD's jumper from VR to VI position?
4. Which settings to make inside the Planet USB CNC software in order to control the VFD?

These are the parameters which are working now but using the VFD's panel (from automationtechinc):

PD001 = 0
PD002 = 0
PD005 = 400
PD004 = 400
PD003 = 400
PD141 = 110 or 220V ( check the spindle rate)
PD142 = 11.0 or 5A
PD144 = 2800
PD008 =110
PD013=1
PD072=400

Attached is the board

Thank you in advance