Re: Vetric Aspire nose dive on Z Axis
Just my two cents here, without reading the entire thread but if it's loosing steps which is what your last photo looks like to me, it may be the driver for the axis. The reason I say this is that because I have a G540 and for a similar reason my Z kept loosing steps and ultimately it turned out to be a faulty driver causing the issue.
Is there a way you can swap the axis drivers, cables, steppers for comparison to each other?
Adam,
Gecko G540, Rack and Pinion Drives-X and A axis, 1/2-10 5 Start Acme-Z Axis
4-THK HSR 25 Linear Slides, KL23H2100-35-4B, Power Supply-KL-600-48 48V