Hi,
I tried the PostProcessors for Vectric inserted in the 20/12 version of TNG but I get an error; I use Aspire 9.0.
I tried to understand more by reading the Post Processor Guide attached to Aspire but without result :-(
Hi,
I tried the PostProcessors for Vectric inserted in the 20/12 version of TNG but I get an error; I use Aspire 9.0.
I tried to understand more by reading the Post Processor Guide attached to Aspire but without result :-(
This variable works in Aspire 10. You can safely comment or delete it.
Grazie.
In effetti, questa guida non ha fatto menzione di questa variabile; Avevo pensato di eliminarlo ma non ne ero sicuro.
What is the name of the postprocessor for the vectric?
USBCNC?
C: \ Programmi \ PlanetCNC \ Samples \ Postprocessors \ Vectric
PlanetCNC_inch.pp
PlanetCNC_mm.pp
OK
I don’t understand how to delete a message. Stupid site, the first time I see this.
Postprocessors for Vectric are included with TNG software. They are in Samples/Postprocessors folder.
Hello,
I will re-use this topic for issue reporting. I was trying to use this script in Vectric 6 PRO. So I have copied PlanetCNC_mm.pp into C:/ProgramData/Vectric/VCarve Pro/V6.0/PostP/.
During starting there are multiple errors showed.
Attachment 439522
After commented this out it showed next error.Code:+VAR DWELL_TIME = [DWELL|A|P|1.2]
Attachment 439524
Last comment and next error.Code:+VAR INVERSE_TIME = [FI|A| F|1.2]
Attachment 439526
After last comment, Vectric started-up successfully. So what is the right way to use this? I am not really sure if can make this or not.Code:+begin DWELL_MOVE +"G04 [DWELL]"
Thank you
I guess VCarve6 is too old and does not support these variables.