[raulmees]

Hello,

I have a FEMCO CNC Mill with Fanuc O-M Control
Trying to set the rs232 setting a guy blocked the control.

Now when turn the machine on I get the following alarm.

100 p/s alarm

- 417 x axis servo alarm
- 427 y axis servo alarm
- 437 z axis servo alarm

The PWE right now is 1 but when I try to change it to 0 I cant, on the screen a message is blinking (NOT READY) and a cannot change from MDI to any other mode.

Any suggestions?

Thank you,

Raul

[jdeere4250]

needtoreloadmemory

[raulmees]

Hello,

Thank you for your response.

Could you tell me how to do that?

Thanks again,

Raul

[memoryman]

DO NOT CLEAR MEMORY.
Look at your parameters: do they look ok? Record your parameters and diagnostics (photograph each page?)
If you have a back-up, correct the parameters that are wrong. Pay special attention to the 900 series (options). The 100 alarm indicates that the power has to be cycled, because an important parameter has changed.
Push Estop: sometimes you need that to change parameters.

[raulmees]

memoryman

Parameters look good. The problem is that I dont able to make changes, the only inputs that I'm allowed to do are in the offset page. Is any other way to disable the Parameter Write Enable?

Thanks for your help.

Raul

[chucker]

The ps 100 just means PWE is a 1 turned on the 3 servo errors with the not ready flashing make me think the machine is not powered up all the way, is there an Estop pushed some where is the another botton you need to push to get the machine in the ready state if not you may have a power supply that has failed.

[Bosttodd]

I can't get the operators panel to come on so I can reload memory. I need the edit button.