I'm currently training in CNC Lathe but I'm running into an issue with the arch. I am currently on a Haas Simulator. My instructions were to use IJK but I'm struggling.
Thanks
Awbrey P
I'm currently training in CNC Lathe but I'm running into an issue with the arch. I am currently on a Haas Simulator. My instructions were to use IJK but I'm struggling.
Thanks
Awbrey P
...try using R for arc center. Read more about it below link
https://www.haascnc.com/service/code...value=G03.html
sip-
The R-value defines the distance from the starting point to the center of the circle. Use a positive R-value for radii of 180 or less, and a negative R-value for radii more than 180.
with out the information on the print it will be hard to give you the correct answer
if the arc is being cut from .440 in the x axis to a smaller x value then back to the .440 dia.(G2)
with the z axis starting at -.565 and finishing at -.940 your k value would be k-.1875
...sim report when fixed. Followup
over vs under Newton's Law
Thank you all for the suggestions but we just
Split the arch into two partials and it worked