586,655 active members*
2,311 visitors online*
Register for free
Login

Thread: Not working anymore

Results 1 to 2 of 2
  1. 04-17-2009, 03:13 PM #1
    nenetwork
    nenetwork is offline Registered
    Join Date
    Feb 2008
    Posts
    48

    Not working anymore

    I had setup Mach 3 and everything was working fine, until today when I tried to Jog the motors and they just made noise.

    1 of the motors is louder than the other 2, another motor is moving slightly then stopping and just making a low amount of noise.

    Is there anyway I can check to see if its a problem with Mach 3 or if its a problem with the stepper motors?
    Reply With Quote Reply With Quote
  2. 04-17-2009, 07:06 PM #2
    nenetwork
    nenetwork is offline Registered
    Join Date
    Feb 2008
    Posts
    48
    btw I had already tuned the motors and they were working fine before this happened.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. G CODE NOT WORKING ANYMORE from Vectric cut2d and 3d
    By TZak in forum LinuxCNC (formerly EMC2)
    Replies: 3
    Last Post: 03-01-2009, 04:51 PM
  2. Can't tighten compound gib anymore!
    By kdoney in forum Mini Lathe
    Replies: 3
    Last Post: 02-04-2006, 08:42 PM
  3. Z-axis won't jog anymore
    By Liv2fish2 in forum DNC Problems and Solutions
    Replies: 5
    Last Post: 01-14-2006, 01:20 AM
  4. Made in the USA..what the hell does that mean anymore?
    By carbidecraters in forum Community Club House
    Replies: 150
    Last Post: 10-28-2005, 09:01 AM
  5. Help! It doen't work anymore?
    By boxwood in forum DNC Problems and Solutions
    Replies: 1
    Last Post: 08-04-2003, 06:29 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules