[LUGOCNC]

I PURCHASED CINCINNATI ARROW 750 IN PERFECT CONDITION IT HAS A PC2100 CONTROL. I MOVED THE MACHINE TO MY SHOP AND HOOKED IT UP. I AM RUNNING IT ON A 30 HP CNC PHASE CONVERTER. THE SPINDLE RUNS FINE IN M03 AND M04. THE PROBLEM IS WHEN YOU COMMAND A M05 WHEN RUNNING IN M03 OR M04 THE SPINDLE WILL NOT STOP IT JUST DRIFTS TO A STOP AND GENERATES A SPINDLE ALARM. I AM A SERVICE TECH FOR OKUMA AND DO NOT KNOW ALOT ABOUT A CINCINNATI. I AM THINKING IT IS IN THE REGIN BUT NOT SURE HOW TO CHECK IT AND WHAT THE SPINDLE DRIVE SHOULD BE PUTTING OUT. CAN ANYONE HELP.

THANKS

MIKE

[LUGOCNC]

I was able to find the problem one of the wires for the regen unit was loose. Machine is running great.

[maxx_007xx]

Hi everybody got some problems with a cincinnati hawk 150 turning with a2100 control.
the machine has failure to do a spindle c-axis alignment. during axis alignment which went through normal procedures. the history of this problem is accidentaly some technician changes the servo configuration axis data parameters.can someone help how to set servo axis data....tnx

[P8TRIOT]

Hey Lugo,

Did you ever get to the bottom of your problem? I'm having the same issue