[Tim123]

Hello all, my first post, anybody seen this before, will it work, I have the chips just need to make pcb, it came from Japan I think, translated by google,
here is the web address
http://translate.google.com/translat...7ADBF%26sa%3DG

& the files as an attachment I hope

[pminmo]

Looks like just backup of eagle board files. Which you can see the copper, with no schematic or parts info, pretty useless.

[Tim123]

Hello pminmo,
You really need to look again, I have schematics & parts info, .sch & .brd files for the 3 axis & a lot of backup files ending with .b#1 or .s#1, if you rename them ending .brd & .sch they will open in Egale, I havn't looked at them all, yet not enough hours in my day for work & play. I will try & post a bitmap from Egale of the 3 axis again here, it has a low resolution of 90 dpi to reduce file size for the upload, if you open the file SLA7062M-3Axis-V2.brd from the web link you will find the original.
Regards Tim

[pminmo]

The verion I downloaded just had .brd files and it's backups...b#1, etc. No sch or s#1, etc...

[rmsimoes]

I presume you will find all files needed at this zip file.
I have tried with 7-zip. winzip was not working ok.

[Tim123]

Hello I found the files in the links below, I have never gone any further with it, its easyier to buy the kit from Hobby cnc in the USA, still very interesting to look at & probably worth the effort if you have the time & skills required to build it.

http://64.233.179.104/translate_c?hl...%3Den%26sa%3DN

http://translate.google.com/translat...%3Den%26sa%3DN

[rmsimoes]

I have been looking for low cost solutions and also reliable. and decide to use an IC from Toshiba. TA8435.
it is easy to build a small board and working in bipolar mode I can find cables anywhere.
good luck with DIY projects.

[AlienSteve]

Anyone built this yet?

[jam213]

hello ,
I can tell you one thing, sla7024 works well, I retrieved photocopieurs module that I was able to operate using the datashet means well PMW