603,894 active members*
2,660 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Fadal > Spindle doesnt stop at end of program
Results 1 to 3 of 3
  1. #1
    Join Date
    Jun 2010
    Posts
    0

    Spindle doesnt stop at end of program

    At the end of the program I am getting the error message "Spindle would not stop". then if I try to run the program again I get the message "Inverter Fault" and "Amplifier fault on Axis C" Can anyone tell me if this is a mechanical or electrical problem? The machine is a VMC 3016 Built 1995.

    Thanks

    Steve

    Seattle WA

  2. #2
    Join Date
    Feb 2008
    Posts
    547
    Let's start with posting the last 5 lines of your program... I'm assuming the spindle is actually stopping? (M05)
    Steve

  3. #3
    Join Date
    Mar 2010
    Posts
    0

    spindle faults

    sounds like the regens are not working ohm wires r1 and r2 coming out of the drive and compare them to what is in the manual,most are around 10ohms also check the large fuse in or around the drive.

Similar Threads

  1. SPINDLE DOESNT START AT G97 S600 M3
    By Jedi in forum Haas Lathes
    Replies: 12
    Last Post: 08-18-2009, 06:57 PM
  2. eliminate start and stop of spindle for short program?
    By endgrainguy in forum G-Code Programing
    Replies: 4
    Last Post: 06-09-2009, 03:06 AM
  3. unidentifiable program stop
    By Dustin L in forum Fanuc
    Replies: 0
    Last Post: 12-11-2008, 01:39 PM
  4. Doesnt load all of the program?
    By dafowfidy in forum Mach Mill
    Replies: 3
    Last Post: 08-07-2008, 02:00 AM
  5. Stop/start a program
    By jimglass in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 3
    Last Post: 06-10-2003, 02:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •