Hello, I am working on a 1995 Tornado 300 series lathe that had turret indexing problems. We sent the Duplomatic turret out to be rebuilt as it was completely destroyed from years of abuse. The lathe has been shut down for about 4 weeks until we got the turret back for installation. The only other improvements we did were new belts, new hydraulic pump, gauges, and operator panel. We have the turret installed and the computer and hydraulic pump will come on but then get 1000 Spindle Fault errors as well as various X and Z axis errors. Does any one have any ideas on this? Any help would be greatly appreciated.

Thanks!

Richard