[imprez55]

Unfortunately I have lost almost every picture of my conversion of an x3 thus far. This includes the picture I took that shows where the wires go from the forward/reverse switch to the spindle motor. I have a few things disassembled now and do not have the stock potentiometer so I cannot test which terminals are correct. Can anyone just quickly look in the back of their x3 and tell me where the motor's positive and negative wires go to?

[Crevice Reamer]

Unfortunately I have lost almost every picture of my conversion of an x3 thus far. This includes the picture I took that shows where the wires go from the forward/reverse switch to the spindle motor. I have a few things disassembled now and do not have the stock potentiometer so I cannot test which terminals are correct. Can anyone just quickly look in the back of their x3 and tell me where the motor's positive and negative wires go to?

I have an SX3, which is different, so I can't just look at mine for you. However, page 27 & 28 of the manual have a pic and wiring diagram:

http://cdn6.grizzly.com/manuals/g0463_m.pdf

Hope this is helpful.

CR.

[imprez55]

Ahh, that's perfect, thank you. I hunted on google for pictures but found nothing, and nothing was in my HF manual so I didn't think to look at the grizzly one. Again, thanks