[Third-Gen]

Have a 1995 Nakamura TMC15 with OT controls. Ive gone through a ton of stuff in the manuals about this. It even SAYS run a part manually, using the MPG, to face and OD a part, measure, adjust offset, etc. If I go to MDI and M03S500 itll start the spindle, but once I flip over to MPG or JOG it stops the spingle. All door interlocks are disabled, so its gotta be either in the ladder or a weird parameter. Driving me nuts having to face and OD using MDI all the time. Anyone?

[zavateandu]

why do not start the spindle with the jog button?
must be CCW nad CW and STOP buttons on panel and also a knob for increasing or decreasing the spindle speed.

[Third-Gen]

these dont work at all, in any mode. not sure if theres a parameter lock somewhere, as i dont have a list of OEM parameters. Also the feedrate doesnt match, doing F10 moves like a rapid, but F.02 seems closer to F10 in reality. lots of things to figure out.

[Third-Gen]

ok went back out ant messed with it more. looks like they DO work, just have to make sure that I hit RESET and clear any MDI info thats still saved in the system. If I go to MPG or JOG and hit CW or CCW now it starts up, and spindle speed knob works, 0-4000rpm now. Still have to figure out the feedrate issue at some point

[drdos]

It is how the ladder was written. You will need someone with the hardware and software to change the ladder so it will do as you need.

[PEGBOARD]

these dont work at all, in any mode. not sure if theres a parameter lock somewhere, as i dont have a list of OEM parameters. Also the feedrate doesnt match, doing F10 moves like a rapid, but F.02 seems closer to F10 in reality. lots of things to figure out.

F10 will move like a rapid if your are in G99 mode (feed per rev)
change to G95 (mm per min) now you can use F10.

[PEGBOARD]

OOoops that should be G98 not G95...

[martingandara]

ok went back out ant messed with it more. looks like they DO work, just have to make sure that I hit RESET and clear any MDI info thats still saved in the system. If I go to MPG or JOG and hit CW or CCW now it starts up, and spindle speed knob works, 0-4000rpm now. Still have to figure out the feedrate issue at some point

I have the same problem with a Fanuc iO Mate-TD. What parameters did you move?