My one set of stepper driver boards MKS TMC2160 works in Mach3 but I had to tick the "Step Low" under motor outputs. I have been unable to find this setting in Mach4 to get the motors running. My other motors using TB6600 drivers work fine
I have Pokeys57cnc board and currently running Mach3 demo, would like to test Mach4 to see what I would prefer to buy.
Anyone with any advice on these settings?
Results 1 to 1 of 1
-
10-07-2023, 05:11 PM #1
Registered
- Join Date
- May 2007
- Posts
- 3
Step Pin invert workes in Mach3 but cannot get it working in Mach4 with Pokeys57cnc
Reply With QuoteSimilar Threads
-
Pokeys57CNC + CL86T + Closed Loop Stepper motor + MACH4
By 8redbull in forum Stepper Motors / DrivesReplies: 0Last Post: 05-11-2023, 02:54 PM -
Mach4 - Pokeys57CNC - PlasmaSense THC issues
By ralcala in forum CNC Plasma / Oxy Fuel Cutting MachinesReplies: 0Last Post: 08-11-2022, 03:14 AM -
SuperPID, Pokeys57CNC, Mach4
By DickDye in forum CNC Machine Related ElectronicsReplies: 0Last Post: 10-06-2020, 11:33 PM -
Where is Pokeys57CNC Pin 55 - and almost there!
By 1875 in forum Mach Software (ArtSoft software)Replies: 5Last Post: 09-20-2020, 03:25 PM -
Is the clock(clk) pin same as step pin?
By Getz in forum CNC (Mill / Lathe) Control Software (NC)Replies: 1Last Post: 08-30-2008, 12:28 PM
Tags for this Thread
Posting Permissions
