[kasevo]

Good day There is a problem with FANUC 0i TD. The program does not start with the CYCLE START button in AUTO mode. In MDI mode, I create the same program and it starts. That is, the MDI mode works, it does not work in the AUTO mode. When I press the CYCLE START button in AUTO mode, there are no errors or warnings on the screen, it just does not respond to pressing the button

[zavateandu]

whne you select the automatic mode you have to check the following:
-in pmc-status screen check if the adress G43.0->1 G43.1->0 and G43.2-> 0
-when you push the cycle start button the adress G7.2->1 or 0 while you press it more times
--check the hold signal in the adress G8.5 MUST BE 1
--check the feedrate on adress G12-If all bits are 0 that means the feedrate is 0
-check the dry run signal in adress G46.7 if it is 1 or 0
-check the interlock signals on axis on adress G8.0 must be 1
-check interlock for each axis on adress G130 .0,G130.1,G130.2,G130.3,G130.4-must be one each bit

Check these and come back with feedback

[kasevo]

whne you select the automatic mode you have to check the following:
-in pmc-status screen check if the adress G43.0->1 G43.1->0 and G43.2-> 0
-when you push the cycle start button the adress G7.2->1 or 0 while you press it more times
--check the hold signal in the adress G8.5 MUST BE 1
--check the feedrate on adress G12-If all bits are 0 that means the feedrate is 0
-check the dry run signal in adress G46.7 if it is 1 or 0
-check the interlock signals on axis on adress G8.0 must be 1
-check interlock for each axis on adress G130 .0,G130.1,G130.2,G130.3,G130.4-must be one each bit

Check these and come back with feedback

Good day. Where can I find the PMC status screen?

[kasevo]

Good day. Where can I find the PMC status screen?

I am new to FANUC equipment. I don't even understand where to find 1 or 0 in PMC parameters in 7.2 and 8.5

[kasevo]

I am new to FANUC equipment. I don't even understand where to find 1 or 0 in PMC parameters in 7.2 and 8.5

The program does not start with the CYCLE START button in AUTO mode - FANUC 0i TD

[zavateandu]

[kasevo]

G7.2 - In AUTO mode, zero does not change to one when the CYCLE START key is pressed. In MDI mode, one appears instead of zero.

[kasevo]

In AUTO mode - G43.0->1 G43.1->0 and G43.2-> 0 . In MDI mode - G43.0->0 G43.1->0 and G43.2-> 0

[zavateandu]