In FeatureCAM turning, when thread cuttng, is there a way to get the thread to "fade out" at the end of the thread instead of relieve groove?
Thank you in advance
Thread: Thread cutting
Results 1 to 1 of 1
-
01-16-2009, 12:01 PM #1
Registered
- Join Date
- Jan 2009
- Posts
- 1
Thread cutting
Reply With QuoteSimilar Threads
-
Need thread cutting help
By Larry Myers in forum Sharp CNCReplies: 1Last Post: 03-08-2008, 06:26 PM -
Need thread cutting help
By Larry Myers in forum G-Code ProgramingReplies: 10Last Post: 03-06-2008, 10:38 PM -
Thread cutting in EMC
By mattinker in forum LinuxCNC (formerly EMC2)Replies: 16Last Post: 02-28-2007, 02:24 PM -
thread cutting FANUC 0i TB
By xavierdemoura in forum FanucReplies: 0Last Post: 09-24-2006, 02:07 AM -
cutting acme thread
By barnesy in forum MetalWork DiscussionReplies: 6Last Post: 09-02-2006, 03:06 AM
Posting Permissions
