603,896 active members*
5,248 visitors online*
Register for free
Login

Thread: TNC 145 DOUBLE AXIS ERROR - FOUND

Results 1 to 3 of 3
  1. 12-17-2008, 09:59 PM #1
    hmc710
    hmc710 is offline Registered
    Join Date
    Jul 2005
    Posts
    179

    TNC 145 DOUBLE AXIS ERROR - FOUND

    ..... AND SAME ERROR: AXIS DOUBLE PROGRAMMED. LOOKS LIKE CODE 358 BUT HARD TO READ.....

    WHAT A NUB! I KNEW THE DOUBLE AXIS WAS USUALLY A PROGRAM ERROR TRYING TO GO TO Y 1.4 , Y 2.3 FOR EXAMPLE BUT THIS ERROR DIDN'T STOP AT THE BAD LINE, BUT A FEW BEFORE IT. PERHAPS THE ERROR "CODE" WAS ACTUALLY THE LINE NUMBER?
    THANKS FOR KEEPING THE WISE CRACKS TO A RESPECTABLE MINIMUM!
    Reply With Quote Reply With Quote
  2. 12-18-2008, 07:12 PM #2
    gus
    gus is offline Registered
    Join Date
    Jan 2005
    Posts
    1121

    re

    Yes, it should say AXIS DOUBLE PROGGRAMMED 22 or somesuch, 22 being the line in question IIRC, It does have look ahead.
    Reply With Quote Reply With Quote
  3. 12-18-2008, 08:13 PM #3
    hmc710
    hmc710 is offline Registered
    Join Date
    Jul 2005
    Posts
    179

    Thanks Gus

    Thanks for the reply Gus, I appreciate it. You are correct!
    By the way, could you help me get this thing hooked up to a pc so I can off line edit programs? I've tried a number of different cables and programs from Heidenhain and other DNC's and have not had any success. Thanks for any help you can point me to.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. New 6-axis Double-Closed-Loop Controller?
    By brccrb in forum News Announcements
    Replies: 28
    Last Post: 03-05-2009, 04:46 AM
  2. Double x axis drive
    By mrfreon in forum DIY CNC Router Table Machines
    Replies: 13
    Last Post: 02-22-2008, 01:03 AM
  3. How to drive double x-axis?
    By zone023 in forum Open Source CNC Machine Designs
    Replies: 5
    Last Post: 04-01-2007, 10:35 AM
  4. Y axis rail- single or double?
    By Corvus corax in forum Linear and Rotary Motion
    Replies: 5
    Last Post: 11-16-2005, 01:42 AM
  5. Double X-axis Drive
    By mícheál in forum DIY CNC Router Table Machines
    Replies: 4
    Last Post: 11-15-2004, 03:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules