548,599 active members*
2,615 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Tree > Tree VMC 750 (Green Button does not work) please help
Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Aug 2021
    Posts
    4

    Tree VMC 750 (Green Button does not work) please help

    Hey there.
    I’ve got a Tree VMC 750 w/ Acramatic controller.

    I’ve got So I’m having 2 problems:
    1) I was trying to align, the table went to the corner, but the Y axis kept overtraveling and error-ing out. Couldn’t get it aligned. I put in a new proximity sensor maybe 4 months ago, for the Y axis, cause it went out and wasn’t reading. It’s been working perfectly until now.

    This was new, so I assumed it was something small. Cleared out the chips from the back wall. Reset it. Slowed down the feed. Tried again. Tried again a couple times, til controller stopped responding. So I turned off the machine, to be try a hard reset, which brings me to problem #2

    2) When I turned the machine back on, it loaded up, but it wouldn’t “start” with the green button as it normally does. So it’s stuck not able to do anything. Air pressure is good.

    I’m assuming this is because axis are over limit on start?

    Does anyone know how to manually move the axis? I’m looking around the machine and I can’t find any “doors” as I’ve read in other posts. Maybe I’m not seeing something.

    Thank you in advance for any help!

  2. #2
    Member
    Join Date
    Oct 2006
    Posts
    54

    Re: Tree VMC 750 (Green Button does not work) please help

    There should be a key switch for “deblock limit switch” I think on the side of the electrical cabinet. Turn the switch, press data reset, then press start. You should be able to jog off switch. Some machine you need to hold the green button or the cntl button to jog. It should stop once you’re off the switch, then turn the key and off you go.

    Bob@ZPS

  3. #3
    Member
    Join Date
    Oct 2006
    Posts
    54

    Re: Tree VMC 750 (Green Button does not work) please help

    Oh… also… clean the chips out of the two grey troughs with covers on the back of the machine.

Similar Threads

  1. VMC 10 green start button
    By Sprew in forum Fadal
    Replies: 9
    Last Post: 11-15-2021, 07:29 PM
  2. Tree VMC 750
    By rzklb in forum Tree
    Replies: 1
    Last Post: 08-06-2017, 02:43 PM
  3. Tree vmc 750 servo info
    By Inskeep in forum Tree
    Replies: 1
    Last Post: 04-06-2017, 06:26 AM
  4. Tree VMC-750...need manuals !
    By Jerry7 in forum Tree
    Replies: 3
    Last Post: 03-18-2014, 03:52 PM
  5. 2001 Tree VMC-750
    By S and S in forum Tree
    Replies: 2
    Last Post: 10-03-2013, 12:12 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •