I am using/learning gibbscam. I have a part imported (its a step file) I am trying to generate toolpath/g code. Everytime I do it does the tool path from the surface i select to the center of the part. I have pointed to the part it goes to. How do I make it stop a a specific depth? I am wanting the toolpath on the z to stop at the green. but it goes down futher.
Here are some pictures.
Thread: trying to learn this stuff.
Results 1 to 2 of 2
-
05-16-2011, 10:30 PM #1
Registered
- Join Date
- Jun 2009
- Posts
- 78
trying to learn this stuff.
-
05-17-2011, 01:18 AM #2
Registered
- Join Date
- May 2011
- Posts
- 29
we have gibbs cam.
I cant zoom in to tell what you are really talking about.
my sugestion at this time is to post your problem at GibbsCAM Support Forums - Powered by vBulletin
there a lot of really sharp people there that could help with your problem.
use it alot.
Reply With QuoteSimilar Threads
-
Learn IGF One touch or Learn a CAM?
By brettcnc in forum OkumaReplies: 9Last Post: 05-08-2012, 02:37 AM -
Fun stuff
By martinw in forum Community Club HouseReplies: 6Last Post: 11-04-2009, 03:22 AM -
New stuff in NX6
By Cammotion in forum UG NXReplies: 2Last Post: 03-10-2009, 03:33 AM -
Mach3 tuning (cuts small stuff fine, but is off on big stuff)
By jdbaker in forum Mach Software (ArtSoft software)Replies: 4Last Post: 03-15-2007, 05:30 PM -
welding thick stuff to thin stuff - need advice
By cross6 in forum Welding Brazing Soldering SealingReplies: 5Last Post: 01-13-2005, 08:39 AM
Posting Permissions
